Docs are still under development. Information will be changing rapidly over the next few months.
Go to Monday.com

Process B: Creating a new assembly and a new part within that assembly

1

Create a new assembly

Find the correct subsystem and select "Add part" and give the assembly a descriptive name and press enter.

2

Assign Assembly ID

Each assembly needs to have a unique identifier in its respective subsystem. Please assign the next available number.

There should never be duplicate Assembly IDs in a single subsystem. Please make sure that you are selecting the next available digit for your assembly

3

Assign Part ID

Each assembly should have a Part ID of 0

Assemblies are not individual parts therefore their Part ID is left as 0

4

Expand the assembly for parts

5

Enter new part

Please type a descriptive name for your part then press enter

6

Set Part Subsystem

Set the subsystem to match the assembly subsystem

7

Set Part Assembly ID

The assembly ID of the part must match the assemblies ID

The assembly ID columns must match otherwise the part numbers will not be correct

8

Set Part ID

Each part needs to have a unique identifier in its respective assembly. Please assign the next available number.

There should never be duplicate Part IDs in a single assembly. Please make sure that you are selecting the next available digit for your part.

PreviousProcess A: Setting Up a SubsystemNextProcess C: Creating a new Part within an existing Assembly

Last updated

Was this helpful?